Sensor Series such as the detection of human movement, the detection of mechanical movement and other object movement, people generally refer to the motion sensor refers to the electronic sensor.
Sensor Series can be used to measure motion related to the position, displacement, velocity, acceleration, vibration displacement, amplitude, wave propagation and other physical quantities.
Sensor Series are widely used in teaching simulation, scientific research, aerospace, telemetry, automation and other fields, and even in the daily life of mobile phones also used motion sensors.
PDLUX PD-PIR112-Z
Equipped With Infrared Sensor Of Projection Lamp has a switching power supply version and a capacitor step-down version. The switching power supply version has a working voltage of up to 100V-277V and a standby power consumption of <0.5W. In principle, the capacitive step-down version can only have a single voltage, and the standby power consumption is >0.7W. You should consider it when choosing a product.
PDLUX PD-PIR152
IP65 Waterproof Infrared Sensor is a PIR sensor switch, utilizes the infrared energy from human as control-signal source and determine the light to need to work or not, and control the light on and off automatically .When one enters the detection filed and trigger the sensor to work ,the light turns on; when one leaves the detection filed and the setting time reaches, the light will turn off.
PDLUX PD-PIR109-Z
IP44 Waterproof Infrared Sensor is an advanced digitally controlled infrared pyroelectric intelligent sensor product. It uses the MCU to accurately calculate the switch information, and accurately controls the relay to be turned on at the zero point of the sine wave, so that each load is turned on. At the zero point of the sine wave, the inrush current problem caused by the conventional control mode when the sine wave high voltage is turned on is avoided, especially the large current damage relay generated by the large-capacity capacitor under the impact of the high voltage under the load.
PDLUX PD-DS1015
Using the original Omron relay which has an ultra small measurement and low power consumption. 24GHz Automatic Door Microwave Sensor has a small internal resistance to make it insensitive to temperature. The reliability is much higher than the common photoelectric-output ones. It’s suitable for different kinds of auto-door-controller also can applicated as a human detector for alarm systems.. Besides, the sensing function can be customized. The sensor has the best cost performance during such kind of products.
PDLUX PD-MV1028
Remote Microwave Sensor is mainly for the adjustment of the delay time from the moment the signal detected and light auto-on till the light auto-off. You can define the delay time to your practical need. But you’d better lower the delay time for the sake of energy saving, since the microwave sensor has the function of continuous sensing, that is, any movement detected before the delay time elapses will re-start the timer and the light will keep on only if there is human in the detection range.
PDLUX PD-MV1009
When use High-power Microwave Inductor, please adjust the sensitivity to an appropriate position you need, please do not adjust the sensitivity to maximum, to avoid the product does not work normally caused by wrong motion.Because the sensitivity is too high easily detect the wrong motion by wind blowing leaves & curtains, small animals, and the wrong motion by interference of power grid & electrical equipment. All those lead the product does not work normally !